Engage Voice | Assigning a target group to a campaign

Last updated on June 30, 2021

Table of contents

Once your target groups and targets are configured, it’s time to assign them to your campaigns.

Assigning a target group

1. Navigate to Dialing > Campaigns.
2. Select a campaign you’d like to add your quota group to.
3. In your campaign’s Configuration page, scroll down to the Dialer Settings section and use the Quota Group Selection field to select which quota group you wish to apply to this campaign.
4. Save your changes via the Save button at bottom right.
Finally, once you have your quota targets created and your quota group assigned to a campaign, it’s time to upload and map your new lead list. Please note that if you upload your lead list before the quota group is created and assigned to a campaign, this feature will not work.
© 1999-2022 RingCentral, Inc. All rights reserved.
We've sent you a link, please check your phone!
Please allow a full minute between phone number submissions.
There was an issue with SMS sending. Please try again. If the issue persists, please contact support.